HOW TO USE

ASSEMBLE THE FOAM SPRAYER:

  1. Simply screw the handle & hose adapter into the fittings.

2. Click the spray nozzle into the fitting.

Note: There are 2 spare rubber washes that do NOT need to be installed.

FILL

Simply fill up the container with 250ml of water. Repeat if the surface is greater than that of a 5-meter Boat / Ute.

PUMP

Using a Salt-Shark Salt Remover, put ONE PUMP in per 250ml of water. Repeat if necessary.

SHAKE

Our concentrate is so thick you NEED TO SHAKE well before spraying. Simply shake until it’s blue and you’re ready to go!

SET THE MIXING RATIOS:

1. Follow the mixing guide on the sprayer container.

2. Adjust the gear wheel to the desired setting, found on top of the sprayer container.

Note: To achieve recommended results & economy set the Gear Wheel to Setting 1

Cover All Surfaces In Foam

Using the Salt-Shark Foam Sprayer, cover your entire surface with Salt-Shark to insure maximum protection and salt removal. Thats it!

RINSE OFF IF YOU NEED

For shiny surfaces rinse off after 30 seconds. For trailers/underbody of the car this is not needed.

0
    0
    Your Products
    Your cart is emptyReturn to Shop